The black Raspberry Pi 5 tray from the front, with the Four Layers name, the four rack holes and the port window

Raspberry Pi 5 Tray, 1U Rack Mount for 10 Inch Racks (Active Cooler)

£25.00
Skip to product information
The black Raspberry Pi 5 tray from the front, with the Four Layers name, the four rack holes and the port window

Raspberry Pi 5 Tray, 1U Rack Mount for 10 Inch Racks (Active Cooler)

£25.00

This tray holds a Raspberry Pi 5 in one space (1U) of a 10 inch rack, with its network and USB sockets at the front. The Pi screws down onto four posts. Its sockets sit in one neat window in the front plate, facing the same way as the ports on our switch tray, so a patch lead between them stays short.

It's made for a Pi 5 with its Active Cooler fitted, and it's 3D printed in black PETG here in Tewkesbury. We've fitted Jon's own Pi 5 to this design.

In the box

  • The tray, 3D printed in black PETG
  • The rear support bar, to hold up the back of the tray
  • 4 M2.5 x 10 screws to hold the Pi down
  • 4 M2.5 square nuts, one for each post
  • A 2mm Allen key for the M2.5 screws

You bring the Raspberry Pi 5 with its Active Cooler. Rack screws, cage nuts and washers aren't included, because 10 inch racks don't agree on fasteners.

How it fits

  • 1U, for 10 inch racks, drawn to the same hole spacing as the rest of our range.
  • The network socket and all four USB ports sit at the front, in one window in the front plate.
  • The USB-C power socket and both micro HDMI sockets face the left side, with room for a plug in each. Plug them in with the tray out of the rack.
  • The power lead runs back through two guides on the left to a tie point at the back, clear of the other sockets.
  • The memory card is at the back end. Take the tray out of the rack and the card comes out with the Pi still screwed down.
  • Each post holds a square nut in a slot. The nut can shift about half a millimetre to meet the hole in the board, but it can't turn, so there's nothing to hold underneath while you tighten the screw.
  • Size: 249mm wide, 230.6mm deep, 1U tall.

Putting your Pi on

  1. Lay the tray flat on a table.
  2. Slide a square nut into each of the two front slots from behind, and push it towards the front plate. Do these first, because the Pi covers them.
  3. Tilt the Pi in with the memory card end raised a little, put its sockets into the front window from behind, then lower the card end onto the posts.
  4. Slide a nut into each of the two back slots from the back. These can go in before or after the Pi.
  5. Fit the four M2.5 x 10 screws.

Then plug in the power lead and any HDMI, run the power lead through the guides on the left, and fix the tray into your rack.

Free UK postage, and 30 days to change your mind on top of your 14 day right to cancel. Not sure it'll fit your rack? Check your rack's hole spacing with our fit guide, or send us a photo of your rails and we'll tell you.

You may also like