1U Netgear Switch Rack Mount Tray for 10 Inch Racks (GS308)
This holds a Netgear GS308, the eight port switch, in one unit of your 10 inch rack. The front's left open, so all eight ports and their lights face you, and there's room to plug straight into every one without lifting the switch out.
There's no strap. Press the switch straight down into the tray and a catch on each side springs over its top edge to hold it there. A low lip across the front holds the bottom of its face, so you can pull a cable out one handed and leave the switch where it is. To lift it out, push the two thumb tabs outwards.
It bolts in on the same four M6 holes as our panels, so it lines up with anything of ours above or below it. There's a rear support bar in the box too. It bolts across your rack's back rails and the back of the tray rests on it, so the tray's held at both ends. The tray itself only screws in at the front, and slides straight out towards you once those four screws are out.
There's no solid floor. The switch sits on bars across the tray, and two X braces underneath keep the tray square. Each side wall has a hexagon cut-out, and four fins across the back each take a cable tie.
We made it to Netgear's own published size for the GS308, but this one hasn't had a real switch in it yet. The catches aren't new. They're the same ones we made for a smaller Netgear switch, and they've already held a real one of those. They're made to fit the GS308's size exactly, though, so if yours is a different version, or you're not sure which you've got, message us before you buy. We'd much rather answer a question than take a return.
The details
- Rack format: 10 inch
- Rack spaces: 1U
- Holds: Netgear GS308v2, the eight port switch
- Made to: Netgear's published size for the GS308, 158 x 101 x 26mm
- Fit: not yet tried with a real GS308 switch
- Front: open, so all eight ports and their lights face out, with a low lip along the bottom
- Holding it in: a sprung catch each side over the switch's top edge, with a thumb tab to let it go. No strap.
- Floor: none, the switch sits on bars across the tray
- Bracing: two X braces underneath
- Side walls: a hexagon cut-out in each
- Cable tidy: four tie fins across the back
- Mounting hole centres: 236.525mm left to right, four M6 holes
- Material: black PETG
- In the box: the tray and a rear support bar. Screws, cage nuts and washers aren't included, because 10 inch racks don't agree on fasteners.
- Made: in small batches in Tewkesbury, Gloucestershire
- Model code: FL-MOUNT-1U-GS308
Each tray goes out with its support bar, so for now it can take a bit longer to reach you than our panels do. If you need it by a certain day, message us before you order and we'll tell you where we are.
Free UK postage, and 30 days to change your mind on top of your 14 day right to cancel.